Again, please bear with me... Let's start with simple pin-out diagrams of the two
types of UTP Ethernet cables and watch how committees can make a can of worms
out of them. Here are the diagrams:
Note that the TX (transmitter) pins are connected to corresponding RX (receiver)
pins, plus to plus and minus to minus. And that you must use a crossover cable to
connect units with identical interfaces. If you use a straight-through cable, one of
the two units must, in effect, perform the cross-over function.
Two wire color-code standards apply: EIA/TIA 568A and EIA/TIA 568B. The codes
are commonly depicted with RJ-45 jacks as follows (the view is from the front of the
jacks):
If we apply the 568A color code and show all eight wires, our pin-out looks like this:
Note that pins 4, 5, 7, and 8 and the blue and brown pairs are not used in either
standard. Quite contrary to what you may read elsewhere, these pins and wires are
not used or required to implement 100BASE-TX duplexing--they are just plain
wasted.
However, the actual cables are not physically that simple. In the diagrams, the
orange pair of wires are not adjacent. The blue pair is upside-down. The right ends
match RJ-45 jacks and the left ends do not. If, for example, we invert the left side
of the 568A "straight"-thru cable to match a 568A jack--put one 180° twist in the
entire cable from end-to-end--and twist together and rearrange the appropriate
pairs, we get the following can-of-worms:
This further emphasizes, I hope, the importance of the word "twist" in making
network cables which will work. You cannot use an flat-untwisted telephone cable
for a network cable. Furthermore, you must use a pair of twisted wires to connect a
set of transmitter pins to their corresponding receiver pins. You cannot use a wire
from one pair and another wire from a different pair.
Keeping the above principles in mind, we can simplify the diagram for a 568A
straight-thru cable by untwisting the wires, except the 180° twist in the entire
cable, and bending the ends upward. Likewise, if we exchange the green and orange
pairs in the 568A diagram we will get a simplified diagram for a 568B straight-thru
cable. If we cross the green and orange pairs in the 568A diagram we will arrive at a
simplified diagram for a crossover cable. All three are shown below.
Selasa, 10 Maret 2009
Langganan:
Posting Komentar (Atom)
ini mengingatkan waktu dulu kuliah, sekalian minta ijin copy-paste bwt latihan dirumah, kalau2 notebook sdh kebeli :)
BalasHapus